Nissan Altima Forum banner
ignition
1-5 of 5 Results
  1. 3rd Generation Altima (2002-2006)
    The Ignition Lock Cylinder failed on my recently purchased 2005 Altima. I replaced the cylinder, however it will not start now. It turns over, but there is no spark. I am assuming I need to either program the key to the ECM or reset the anti-theft system somehow - any advice or help would...
  2. 2nd Generation Altima (1998-2001)
    Hey all, My girlfriend has a 1998 Altima GXE that appears completely dead. We tried to get into it yesterday morning and got no response from the key at all - no lights, no noises, nothing. My first thought was that the battery had drained, no big deal we'll jump it. But we're getting nothing...
  3. 1st Generation Altima (1993-1997)
    So on Friday afternoon on my break from work, I was in my car and turned it on with the key to keep warm. After a few minutes of the engine running I took the key out and put it in the ignition again to charge my phone. After I tried to start it up the second time, I couldn't get it to start...
  4. 3rd Generation Altima (2002-2006)
    Hi , ive recently aquired a 2004 Nissan Altima from a friend who lost the key . I had another friend with a 04 altima , same motor etc, that had bad motor . i took the key, ign switch , immobilizer box and ecm (on rt side of car) all from the same car and swapped it out . car still wont start ...
  5. 2nd Generation Altima (1998-2001)
    Hey guys, So my sister-in-law has a 2001 Altima GXE with around 113k miles on it. A couple months ago she had some nitwit install an amp and sub in her trunk and the guy used self-tapping screws to secure the amp to the trunk floor. Long story short, one of the screws went through the top of...
1-5 of 5 Results
Top