Nissan Altima Forum banner

Torque Specs for 2022 Altima Air Compressor Mounting Bolt & Hose screws

428 Views 5 Replies 3 Participants Last post by  jmomojuel
Just looking for the torque specs on these.

Thanks in advance!
1 - 6 of 6 Posts
I don't think there are any changes from a '19, the compressor bolts are 18 lbs/ft and the line retaining screws are 39 lbs/in (3.25 lbs/ft). Spec is the same for both the KR20 and PR25. I can double-check the numbers for a '22 tomorrow at the shop if you like.
  • Like
Reactions: 1
I don't think there are any changes from a '19, the compressor bolts are 18 lbs/ft and the line retaining screws are 39 lbs/in (3.25 lbs/ft). Spec is the same for both the KR20 and PR25. I can double-check the numbers for a '22 tomorrow at the shop if you like.
If you could that would be awesome! Just the mounting bolts and the suction/discharge screws.

THANKS!
You're most welcome. I just looked, the '22 is the same numbers.
  • Like
Reactions: 1
You're most welcome. I just looked, the '22 is the same numbers.
Much appreciated! 🙏
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top